This remote module can be used to connect with the user's automated casting and molding equipment PLC, read the user's device program, and remotely modify, upgrade, and view equipment failure warnings in real-time

We will specifically introduce several methods for the sand mold of the horizontal parting casting molding machine to timely discharge the gas generated by high temperature in the mold cavity during the pouring process of molten metal:

The 13th China International Casting Exhibition, hosted by the China Foundry Association on May 16, 2018, was grandly held at the Beijing Exhibition Center in the capital of China. As a manufacturer of automated casting molding equipment, the Zoom team responded to the warm invitation of the China Foundry Association and actively participated in this international casting exhibition.

On November 11, 2017, Mr. Zhi Xiaoheng, Executive Vice President of China Foundry Association, Mr. Jing Liwen, Assistant Minister of Education and Training Department, and Mr. Zhao Zhili, an expert and professor at Shenyang University, visited ZOOMZU to inspect the work

Donate books, learning stationery, computers and other educational supplies to rural primary schools, support the development of education in rural areas, and care for the learning and physical and mental health of young people and children.

There are many factors that need attention and treatment in the treatment and mixing of tidal sand. If one or more critical conditions cannot be maintained within the control range, the mixed wet sand without good conditions will directly affect the quality of the generated castings

The fundamental difference between the traditional semi-automatic molding machine and the fully automatic horizontal parting casting molding machine lies in the fact that the automatic molding machine uses hydraulic cylinders to compress the sand inside the sand box in one go and with high strength, which has certain requirements for the hardness and strength of the mold to avoid damage to the mold when the compaction pressure increases during the sand mold compaction process;

Below is a brief analysis of the identification methods for ductile iron castings and gray iron castings for everyone